Network Node Parameters

Network node Configuration Parameters

To configure each mobile network node type, you need the parameters below:

Parameter nameDescription Applies to Values or example Notes
PC Type Type of the SS7 Point Codes Entire network ITU, ANSI
NINetwork Indicator Entire network national, reserverdnational, international
PC SS7 Point Code Each SS7 node 1035, 1-107-5
GT SCCP Global Title MSC, VLR, SGSN, HLR 882500010May be shared by all components running on a SS7 node
MGT Type Type of GT used for IMSI addressing Entire network E.212, E.214
CCCountry Code prefix Usually entire network 882VPLMN components located abroad should have local CC
Node number Identity in a cluster VLR, SGSN 1 to 10 bits integer Can be same for VLR and SGSN if a 1:1 relationship exists
Node bits Bits for identity VLR, SGSN, YateBTS 1 to 10 Can be same for VLR and SGSN if a 1:1 relationship exists
IGWMSC Outbound calls gateway MSCProtocol specific Typically the GMSC is also IGWMSC
Roaming No Pool of Roaming Numbers VLR 882990020-882990049 The pool can be shared with handover numbers
Handover No Pool of Handover Numbers MSC882990050-882990059 The pool can be shared with roaming numbers
SGSN GTP-C GSN IP Address SGSN IP Address Alternative (or only) IPv6 address may be present
SGSN GTP-U GSN IP Address SGSNIP Address May be same or different from the GTP-U Address

Parameters for an M3UA connection to a GW/STP

Parameter nameDescription Values or example Notes
Remote Address IP Address on the gateway IPv4 or IPv6
Remote PortSCTP Port on the gateway1-65535
Local AddressLocal bound IP Address IPv4 or IPv6 Optional, required for multihoming
Local PortLocal bound SCTP Port 1-65535Required by some gateways, may cause trouble
ASP IdIdentification of local ASPnumberOptional, required by some gateways and configurations
ContextsM3UA Contexts to requestList of numbersSome gateways accept or require an empty list
GW PCPoint Code of the GWPoint CodeThis is the adjacent Point Code
MTP Routed PCPoint Codes of other nodesList of PCs
GTT PCPoint Code of the GT TranslatorPoint CodeDefault is same as GW PC

Parameters for each M2PA link to a STP

Parameter nameDescription Values or example Notes
Remote Address Remote IP AddressIPv4 or IPv6
Remote PortSCTP Remote Port1-65535
Local AddressLocal bound IP Address IPv4 or IPv6 Optional, required for multihoming
Local PortSCTP Local Port1-65535
STP PCPoint Code of the STPPoint CodeThis is the adjacent Point Code
MTP Routed PCPoint Codes of other nodesList of PCs
GTT PCPoint Code of the GT TranslatorPoint CodeDefault is same as STP PC