SDR LTE and GSM in a single Base Station

LTE for bandwidth and GSM for voice are a match made in heaven for subscribers. The roll-out however, not so much. Having them both from the same radio equipment (BTS/eNodeB) can be the answer. The SatSite can run both YateBTS (GSM) and YateENB (LTE) at the same time, in the same spectrum, using the same radio hardware.

Software-defined BTS & BSC

This is made possible by replacing commonly used FPGA and DSP boards with one Intel Atom chipset. Both the GSM YateBTS and the LTE YateENB are modules implemented in software, allowing the base station to be reprogrammed or reconfigured to support new protocols. A base station can run GSM at first, and can be later software-upgradeable to LTE, running multiple air interface protocols using the same radio, at the same time.

Mixed 2G/4G spectrum allocation

From a spectrum point of view, as seen in the image below, the mixed GSM/LTE technology enables a base station to be software-configurable for up to 4-TRX/ARFCN. A base station can use the 850, 900, 1800, and 1900 MhZ bands for both GSM and LTE, meaning that it will allocate two ARFCN to GSM and will use the remaining spectrum for LTE.

SatSite LTE eNodeB and GSM BTS mixed spectrum

Based on the subscribers’ activity (data vs. voice), operators can assign in software the spectrum priority for either LTE or GSM, so LTE gets a higher priority if there is a lower use of voice services. This optimizes the resources allocation in the network and supplies better access to users.

The YateBTS and YateENB radio modules

Yate is an underlying part of the software architecture of our mixed 2G/4G RAN. It has a highly expandable architecture that provides unified management and monitoring. Both YateBTS and YateENB are software modules based on Yate. Yate’s SDR architecture enables the LTE and the GSM modules to use the same radio hardware. You can find out more about Yate’s multiple modules here.

YateENB (eNodeB) and YateBTS (BTS) running on SatSite for mixed RAN eNodeB/BTS

Yate’s SDR architecture also enabled us to replace the conventional, special purpose equipment combination of a baseband unit (BBU) + a remote radio unit (RRU), with a single unit. With this technology we implemented all the functions of both a conventional base station and a base station controller, eliminating the costly Abis interface for traffic and signaling, as well as partial functions of an Mobile Switching Center (MSC), in terms of mobility, power and frequency management and handover.

The mixed 2G/4G RAN technology is embodied in our SatSite base station. SatSite acts more like a conventional eNodeB, even when running on GSM, because it uses IP backhaul for both 2G and 4G. It also contains the IP list of all neighboring SatSite units.

Using off-the-shelf hardware and a generic operating system, SatSite embraces everything SDR stands for, and is the solution for an easy adoption of new standards or technologies, even 5G in the future.