Enable LTE enb mode
1. When you first enter the Local Management Interface (LMI), you are required to select the appropriate working mode. Click the Modify button to choose LTE enb.
2. Select the LTE enb working mode and click the Save button.
3. Click the ENB Configuration tab. In the Radio – eNodeB section you must set up the following parameters:
- choose Band 8 (Americas) if you are in Europe, Middle East, Asia, Africa or Oceania
- choose Band 5 (typical for the rest of the World) if you are in the Americas.
- 3450…3799 for LTE Band 8
- 2400…2649 for LTE Band 5.
Note: Choose a value in the middle of the range. The Channel Bandwidth you’ve set might take you out of the range if the EARFCN is at the lower or upper limit and you will end up with a non-working configuration. Note 2: The LabKit will set the uplink EARFCN automatically.
Connect EnodeB to HostedCore
- Settings of the photos below will connect your YateENB to Hosted Core
IP addresses starting with 100.127. are OpenVPN private addresses. Your LTE LabKit is already connected to Hosted Core and with these settings you will use Hosted Core as MME.
Be aware that your LTE LabKit OpenVPN IP address won’t be 100.127.0.5, pick up from each drop-down your assigned IP address.